1-1/2" x 3/4" Polyurethane Bushing x 1.450 Long.  Used for 2-1/2" wide YJ springs at main eye and some aftermarket springs at the shackle end. Used at main eye of CJ rear springs 2-1/2" wide.  Also used in our JM25840 & JM25840L motor mounts. Sold each.

3/4" OD x 3" Long Drilled Sleeve for 9/16" BoltSold individually.

Have you got a Jeep with the rear leaf Springs Over the Axle (S.O.A.), and the rear spring "wrap" is causing problems? We have the answer for you! This H.D. Traction Bar will prevent all spring wrap, without limiting travel or flexibility.The Johnny Joint® mounted shackle attaches to...

Have quality bushings in your springs and frame mounts but want to replace your wimpy Jeep shackles? Purchase our shackle side plates found on all of our lubeable shackle sets. Shackle plates are laser cut out of 3/8" steel for a super strong replacement.Zinc plated, sold individually.

M.O.R.E is now offering several lengths of D.O.T stainless steel braided brake lines for virtually any Jeep! Replace the old rubber ones before they break, or if your working on a custom project, order the length you need.Sold individually.

3/4" OD x 3" Long Drilled Sleeve for 1/2" BoltSold individually.

If you want to fabricate your own Steering Brace, then you can purchase a M.O.R.E. Steering Box Clamp.Zinc Plated (clamp and hardware only) 

M.O.R.E is now offering several lengths of D.O.T stainless steel braided brake lines for virtually any Jeep! Replace the old rubber ones before they break, or if your working on a custom project, order the length you need.Sold in pairs, includes mounting bracket & compression washers

Replace the stock rubber transmission and torque arm mounts with these black polyurethane units. They are not affected by oil or grease, road grime, or salt. They will tighten up the way your Jeep feels and help to hold the drive train in place. Fits 1972-1995 Jeeps. Polyurethane....

These block plates allow you to now mount a Chevy LS motor (Gen III & IV) if you already have our JM200 or JM400 motor mounts by just swapping the block plates.  Now that rock crawling has become the favorite past time for Jeepers and we are putting...

1-3/4" x 3/4" polyurethane bushing x 1.450" long, used for the following motor mounts: JM100 JM200 JM301 JM400 JM500 JM700

Fits 2-3/4" axle diameter. These weld on spring mounts are 2.5" wide, 7" long (anti-wrap design). They have three holes cut on 1" centers for adjustability of the leaf spring so you can place the axle where you want to. Manufactured in Colorado, laser cut and CNC formed...