1" OD x 3" Long Drilled Sleeve with a hole for a 1/2" Bolt for spacing our shackle side plates.  The sleeve is used as the center bolt spacer in our LS9034, LS9039, LS9040, LS9081, & LS9091 lubeable shackle kits.Sold individually.

5/8" High Deflection Misalignment Washer Only. 5/8" bolt hole x 5/16" tallSold individually.

Fits 2-3/4" axle diameter with special offset for spring over axle conversion. These weld on spring mounts are 2.5" wide, 7" long (anti-wrap design). They have three holes cut on 1" centers for adjustability of the leaf spring so you can place the axle where you want to....

Want to build your own or just replace existing bolts? Here you go.Sold individually.

Tired of breaking the grease zerk off your bolts? We have the answer with our new "Zerk Protectors" for greasable shackles.Sold individually.

1" OD x 2.5" Long Drilled Sleeve with a hole for a 1/2" Bolt for spacing our shackle side plates.  The sleeve is used as the center bolt spacer in our LS9035 lubeable shackle kit.Sold individually.

Now that rock crawling has become the favorite past time for Jeepers and we are putting our Jeeps in places that they were never designed to go, the stresses on the stock Jeep motor mounts are tremendous. With deep gearing, big tires, lockers, and mega torque, the stock...

Have quality bushings in your springs and frame mounts but want to replace your wimpy Jeep shackles? Purchase our shackle side plates found on all of our lubeable shackle sets. Shackle plates are laser cut out of 3/8" steel for a super strong replacement.Bare steel, sold individually.

Tired of breaking the grease zerk off your bolts? We have the answer with our new "Zerk Protectors" for greasable shackles.Fits 1/2" Zerk Bolts M.O.R.E. part #s S10191 or S10193Sold individually.