These heavy duty spring hangers are great direct replacement units for serious rock crawling and abuse. Reinforced and designed for stock springs, aftermarket lift springs, spring under axle, spring over axle. The YJ shackle hangers are a weld on heavy duty factory replacement (SR103). 

Want to build your own or just replace existing bolts? Here you go.Sold individually.

Fits 2-1/2" axle diameter for YJ Dana 30 axle. These weld on spring mounts are 2.5" wide, 7" long (anti-wrap design). They have three holes cut on 1" centers for adjustability of the leaf spring so you can place the axle where you want to. Manufactured in Colorado,...

M.O.R.E. stocks the special yoke needed to adapt the Ford 8.8 rear axle pinion flange with a 3 inch center to center bolt pattern to the stock Jeep XJ, YJ, or TJ (1310 series) U-joint. This bolts on the Ford flange and allows you to install your XJ,...

M.O.R.E. Lubeable Jeep Shackles are made from 3/8" thick steel. A thick walled center brace bolts in place with grade 5 hardware. The shackle bolts are drilled and fitted with a zerk to allow the grease to flow into the "channeled" black polyurethane bushings.* Crimp-Loc nuts keep all...

The front pivot brackets are fully welded and powder coated. They bolt to the stock shackle mount and lower front bumper mounting holes and a hole that you must drill in the frame. Your shackles will hang from a weld-in tube through the frame. This is important for...

This kit is built M.O.R.E. Bomb Proof. The Spring Perches and U-Bolt plates are made out of 1/4" plate steel. The shock mounts are made out of 3/16" plate, unheard of thickness for these parts. 5/8" holes in U-bolt plates for 9/16"-U bolts.

1-1/2" x 3/4" Polyurethane Bushing x 1.450 Long.  Used for 2-1/2" wide YJ springs at main eye and some aftermarket springs at the shackle end. Used at main eye of CJ rear springs 2-1/2" wide.  Also used in our JM25840 & JM25840L motor mounts. Sold each.

3/4" OD x 3" Long Drilled Sleeve for 9/16" BoltSold individually.

M.O.R.E. Lubeable Jeep Shackles are made from 3/8" thick steel. A thick walled center brace bolts in place with grade 5 hardware. The shackle bolts are drilled and fitted with a zerk to allow the grease to flow into the drilled inner sleeves and the "channeled" black polyurethane...

M.O.R.E. Lubeable Jeep Shackles are made from 3/8" thick steel. A thick walled center brace bolts in place with grade 5 hardware. The shackle bolts are drilled and fitted with a zerk to allow the grease to flow into the drilled inner sleeves and the "channeled" black polyurethane...

Have quality bushings in your springs and frame mounts but want to replace your wimpy Jeep shackles? Purchase our shackle side plates found on all of our lubeable shackle sets. Shackle plates are laser cut out of 3/8" steel for a super strong replacement.Zinc plated, sold individually.