Jeep Wrangler YJ

M.O.R.E. has a new style "Bomb Proof" motor mount available. Instead of using polyurethane for insulating the chassis from engine vibration, we use Torsion rubber. These fine mounts keep the engine clamped in place far better then the stock motor mounts, yet do not transfer vibration like the...

Now that rock crawling has become the favorite past time for Jeepers and we are putting our Jeeps in places that they were never designed to go, the stresses on the stock Jeep motor mounts are tremendous. With deep gearing, big tires, lockers, and mega torque, the stock...

M.O.R.E. invented the one inch Jeep body lift "Puck" over 20 years ago. With the need to keep increasing tire sizes and a new generation of flexible suspension systems, it has become a necessity to move the body away from the frame for increased tire clearance. One inch...

Now that rock crawling has become the favorite past time for Jeepers and we are putting our Jeeps in places that they were never designed to go, the stresses on the stock Jeep motor mounts are tremendous. With deep gearing, big tires, lockers, and mega torque, the stock...

This motor mount kit is designed for your Jeep® vehicle, creating a crossmember with the engine, improving clutch linkage operation, and beefing up your Jeep® for serious wheelin'. Mounts the engine its stock location. Fits the following 6-cylinder engines 4.0L or 4.2L: 1987-95 Jeep® YJ 1997-06 Jeep TJ,...

M.O.R.E. stocks the special yoke needed to adapt the Ford 8.8 rear axle pinion flange with a 3 inch center to center bolt pattern to the stock Jeep XJ, YJ, or TJ (1310 series) U-joint. This bolts on the Ford flange and allows you to install your XJ,...

M.O.R.E is now offering several lengths of D.O.T stainless steel braided brake lines for virtually any Jeep! Replace the old rubber ones before they break, or if your working on a custom project, order the length you need. Sold individually.

If you want to fabricate your own Steering Brace, then you can purchase a M.O.R.E. Steering Box Clamp. Zinc Plated (clamp and hardware only) 

M.O.R.E is now offering several lengths of D.O.T stainless steel braided brake lines for virtually any Jeep! Replace the old rubber ones before they break, or if your working on a custom project, order the length you need. Sold in pairs, includes mounting bracket & compression washers

These block plates allow you to now mount a Chevy LS motor (Gen III & IV) if you already have our JM200 or JM400 motor mounts by just swapping the block plates.  Now that rock crawling has become the favorite past time for Jeepers and we are putting...

Fits 3-1/4" axle diameter. These weld on spring mounts are 2.5" wide, 7" long (anti-wrap design). They have three holes cut on 1" centers for adjustability of the leaf spring so you can place the axle where you want to. Manufactured in Colorado, laser cut and CNC formed...

M.O.R.E is now offering several lengths of D.O.T stainless steel braided brake lines for virtually any Jeep! Replace the old rubber ones before they break, or if your working on a custom project, order the length you need. Sold in pairs, includes mounting bracket & compression washers.